Failure in preparing Backup image, Errors 0x807800C5, 0x80780081
If when you attempt to create a organisation prototype backup on your Windows ten device, and the operation fails with the mistake codes 0x807800C5 and 0x80780081, then this post is intended to aid you lot. In this post, we provide the most suitable solutions to apace resolve this issue.
Failure in preparing the backup prototype of one of the volumes in the backup prepare
When y'all run into this issue, you'll receive the following full error message;
Create a system image
The backup failed.
There was a failure in preparing the backup image of ane of the volumes in the backup set. (0x807800C5)
Additional Information:
The specified backup disk cannot be found. (0x80780081)
Arrangement Image Backup errors 0x807800C5, 0x80780081
If you're faced with any of these fault codes, you can try our recommended solutions and come across if whatsoever of them aid you lot resolve the result.
- Free up storage space on the target drive
- Remove the EFI Sectionalization from the onetime bulldoze (applies to multiple disk setup)
- Temporarily disable your security software
- Execute the operation in Make clean Kick Country
- Use 3rd-party imaging software
Let'south accept a wait at the description of the process involved concerning each of the listed solutions.
1] Free up storage space on the target drive
If you lot're trying to create the system paradigm on an external drive with insufficient storage infinite, you lot're most likely to run across this error. In which case, you lot should free up disk space on the target drive, past transferring your files to another drive or moving your file to a cloud storage service.
After you have moved your files from the disk or in that location is no of import data on the target deejay, you tin now format information technology to NTFS then start to create a system prototype over again.
2] Remove the EFI Partition from the old bulldoze (applies to multiple disk setup)
PC users who had the post-obit like configuration were experiencing this issue:
Windows was originally installed on a disk but later on moved/migrated the installation to some other disk on the same reckoner. Formatted the old deejay to apply one-half for the Organisation Image Backup and a one-half for storage. At present, creating the system image fill-in on the old disk triggers these two errors. Here, the problem was that the sometime drive still had those ii partitions ( EFI System Segmentation and Recovery Sectionalization) from the previous Windows.
In this scenario, to set the result, open Disk Management and delete those two partitions. Alternatively, you tin use DiskPart to delete the partitions. Once deleted, restart your figurer and attempt the organization image fill-in over again – the functioning should consummate without these errors.
Read: System Image Fill-in fails with error codes 0x807800C5 and 0x80070020.
three] Temporarily disable your security software
You may temporarily disable your security software and then run Organization Restore and see if that helps yous.
four] Execute the operation in Clean Boot Country
A Clean Boot is performed to starting time Windows by using a minimal fix of drivers and startup programs. This helps eliminate software conflicts. In a clean boot state, y'all tin run into if the operation completes successfully.
5] Use tertiary-political party imaging software
If neither of the above solutions worked, you tin can use whatever of the tertiary party Imaging, Backup, and Recovery Software for Windows 10 to create the system image fill-in.
Promise this helps!
Related posts:
- System Image Backup fails with error codes 0x807800C5 and 0x8078004F.
- Volume Shadow Re-create Service functioning failed (0x807800A1), The writer experienced a transient mistake (0x800423F3).
Source: https://www.thewindowsclub.com/system-image-backup-fails-0x807800c5-0x80780081
Posted by: campbellsciet1985.blogspot.com
0 Response to "Failure in preparing Backup image, Errors 0x807800C5, 0x80780081"
Post a Comment